Datasheet
IRS2186(4)(S)PBF
4
www.irf.com
© 2015 International Rectifier
April 30, 2015
Absolute Maximum Ratings
Absolute maximum ratings indicate sustained limits beyond which damage to the device may occur. All voltage
parameters are absolute voltages referenced to COM. The thermal resistance and power dissipation ratings are
measured under board mounted and still air conditions.
Symbol
Definition
Min.
Max.
Units
V
B
High side floating absolute voltage
-0.3
620
†
V
V
S
High side floating supply offset voltage
V
B
- 20
V
B
+ 0.3
V
HO
High side floating output voltage
V
S
- 0.3
V
B
+ 0.3
V
CC
Low side and logic fixed supply voltage
-0.3
20
†
V
LO
Low side output voltage
-0.3
V
CC
+ 0.3
V
IN
Logic input voltage (HIN & LIN)
V
SS
- 0.3
V
CC
+ 0.3
V
SS
Logic ground (IRS21864)
V
CC
- 20
V
CC
+ 0.3
dV
S
/dt
Allowable offset supply voltage transient
—
50
V/ns
P
D
Package power dissipation
@ T
A
≤ +25°C
8 lead PDIP
—
1
W
8 lead SOIC
—
0.625
14 lead PDIP
—
1.6
14 lead SOIC
—
1
Rth
JA
Thermal resistance, junction to
ambient
8 lead PDIP
—
125
°C/W
8 lead SOIC
—
200
14 lead PDIP
—
75
14 lead SOIC
—
120
T
J
Junction temperature
—
150
°C
T
S
Storage temperature
-50
150
T
L
Lead temperature (soldering, 10 seconds)
—
300
Recommended Operating Conditions
The input/output logic timing diagram is shown in figure 1. For proper operation the device should be used within
the recommended conditions. The V
S
and V
SS
offset rating is tested with all supplies biased at 15 V differential.
Symbol
Definition
Min.
Max.
Units
V
B
High side floating absolute voltage
V
S
+ 10
V
S
+ 20
V
V
S
High side floating supply offset voltage
††
600
V
HO
High side floating output voltage
V
S
V
B
V
CC
Low side and logic fixed supply voltage
10
20
V
LO
Low side output voltage
0
V
CC
V
IN
Logic input voltage (HIN & LIN)
V
SS
V
CC
V
SS
Logic ground (IRS21864)
-5
5
T
A
Ambient temperature
-40
125
°C
†
All supplies are fully tested at 25 V and an internal 20 V clamp exists for each supply
††
Logic operational for V
S
of -5 V to 600 V. Logic state held for V
S
of -5 V to –V
BS
(Please refer to the Design Tip DT97-3
for more details)