Data Sheet

IRONBOY USER MANUAL Ver.1.03_Eng

Caution - 1.4. Battery and Charger

Things need to know to use Battery and Charger properly.

1. After full charging, IRONBOY can be operated between 10~30min according to motion level.

2. Basically, it is highly recommended to charge the battery full before use, then remove charger when

charger shows green LED. Operate robot until robot shows low battery alarm in the red LED on the

chest. (Or, 20% battery level on Total manager software) After that, charge the battery full again.

3. On the charger, green LED will be ON when battery is fully charged. Please note that charging will be

ceased after full charging even if green LED keeps ON for battery safety. To charge battery again,

please disconnect and connect charger, but it is NOT recommendable to charge “fully charged” battery

repeatedly for safety.

4. Battery level on Total Manager Software will be shown as below.

- When charger is DISCONNECTTED : Actual level of battery remains

- When charger is CONNECTTED : Real-time charging current level. Note the figure is NOT actual

level of battery remains.

▶▶Real-time charging current will be shown on the Total manager software when charger is

connected. Please remember the figure is NOT actual level of battery remains. Under low

battery condition, if user misunderstand the figure is actual level of battery, and try to

operate the robot aggressively, battery may be discharged completely which leads bad

influence on battery lifespan.

5. After power on the robot, 16pcs of servo motors are trying to keep its positions even if there is no

motion and consume some current continuously. Please note that discharging rate can be bigger than

charging rate even if charger is connected when robot power is ON.

6. If robot needs to be operated for more than 30min, it is recommended to have spare battery so that

user can replace the battery to operate robot continuously.

Use properly.

1. Use genuine charger and battery supplied by IR Robot.

2. Charge battery full for next use. Use the robot under full charging condition. It will take 1 hour 30mi for

full charging. Do NOT operate the robot continuously under low battery condition for battery lifespan.

3. It is recommended to disconnect the charger during robot power is ON. (to prevent

misunderstanding between actual level of battery remains and real-time charging current.)

4. When battery shows low battery alarm in the red LED on the chest or, Total manager software shows 20%

battery level, please cease operation and charge the battery again (or replace with fully charged battery)

5. After full charging (Green LED on the charger), charging will be ceased even if green LED is ON. For

safety, do NOT charge “fully charged” battery repeatedly. Otherwise, battery may get hot and may

cause fire or explosion.