Data Sheet

IRONBOY USER MANUAL Ver.1.03_Eng

Set "Move Time" value to control moving speed of concerned Step motion.

Set "Stop Time" value to control delay time to next step motion.

You can set LEDs in chest and Piezo of current step. Check desired

function(LED and Piezo) and you will see different colors and hear

different sound for each number.

Create next step by clicking icon. You can repeat the same as 1st

step to make a 2nd step.

To make "Repeat section" for certain steps, click "Motion property" button.

You can set desired repeat section by put start and end step

number. Left picture shows repeat section is made between

Step 2 and Step 5.

You can see that acceleration rate is set at 1.05x and it is

repeated 3 times. Acceleration will be increased whenever

it is repeated by 1.05x rate.

For the rest of setting, please refer to the page 31.

You will see "O" mark in RPT when you set repeat section for certain steps. "X" means that

they are not in repeat section. Repeat section will be continued as below.

- Control App : During concerned buttons are pressed.

- Motion test in Total manager software : Until Stop button in motion test window is

pressed.

For step 6(not in the repeat section), it will be executed after step 5 when stop button is

pressed in the Total manager software. (or remove finger from the button in the APP.)