Data Sheet

IRONBOY USER MANUAL Ver.1.03_Eng
11
Connect the genuine battery (1500mA, 6V NiMH) with this connector to supply power.
 Charging Connector
Connect the genuine charger to charge the battery. Full charging will take about 2 hours.
(3) Top
① IR Remote Sensor
IR remote controller is not included in the package, but you may use "SAMSUNG" remote controller or its
compatible universal remote controller. Simply save information in IRONBOY defining respective motion and
concerned button on the remote controller according to remote code table.
② Firmware Update Swtich
To enter into firmware update mode for main board, press & hold this button and then power on the robot.
 Main Board USB Connector (Micro-B Type)
USB connector to connect IROBOY's main board with your PC. Using Total Manager software, various tasks like
robot setting, motion setting/editing, and motion download can be done.
 IRduino USB Connector
USB connector to connect IRduino board and your PC.
IRduino Power Connector
Use this power connector when you want to use IRduino board individually to supply power to IRduino
Input voltage : 6V ~ 12V
※ NOTE : Even if power is supplied to IRduino board through this connector, power is not supplied to
IRONBOY's main board or its main body.
① IR Remote Sensor
② Firmware Update Switch
 Main Board USB Connector
④ IRduino USB Connector
⑤ IRduino Power Connector