Installation Guide

Support Strips
This step is to ensure that the bottom of the sink has enough support.
Construct a wood support frame to fit inside the cabinet opening. Allow adequate
clearance for the water supply lines and drainage system.
The recommended support frame design is shown in the illustration on the
left, which consists of four vertical supporting strips, two horizontal supporting
strips and one supporting board. Due to the variety of installations possible with
this sink, your installer may suggest a different support frame design.
IMPORTANT: Base cabinet and wood support frame are essential for
proper installation. The weight of the sink when full is approximately 300 lbs.
Base cabinet and support frame must sufficiently support this weight.
Support Board
Using two people, carefully place the sink in place. Verify
t
hat the sink can fit in the cabinet opening and rest properly
on the supporting system. Make a small adjustment to fit as
necessary.
Verify the overall appearance and check for levelness to
ensure correct drainage.
IMPORTANT: Risk of personal injury or product
damage. Handle with care. The product can break,
chip, cause injury or product damage.
iptsink.com