Users Manual Part 3

5. Quickly insert and remove a Diagnostics card from the card reader to enter Diagnostics mode.
6. Press √ OK > X Cancel to enter Diagnostics mode - level 2.
7. Press + Time (more time) / — Time (less time) to select COMMS Test.
8. Press √ OK to enter the COMMS Test menu, to set the meter to the current time.
9. Press + Time (more time) / — Time (less time) to select Replace Bat.
10. Press √ OK to enter Replace, then press — Time (less time) to confirm the battery replacement.
The battery replacement Date is set to the current time, and the Use data resets to zero (0) days.
11. Press X Cancel repeatedly to exit Diagnostics mode.
How To Force an SSPM to Update
This task topic discusses how to force the IPS Group, Inc. SSPM to update.
The SSPM receives firmware updates and configuration updates through the DMS. At initial installation, the SSPM is configured to call-into
the DMS for updates at a specific events and / or time interval. To test an SSPM's communications, or to initiate an immediate updated, it
can be forced to call-in at any time (before the next specified call-in interval).
To force an SSPM to update:
1. On the SSPM, quickly insert and remove a Diagnostics card from the card reader to enter Diagnostics mode.
2. Press + Time (more time) / — Time (less time) to scroll to Comms Test.
3. Press √ OK to Start the communications test.
The SSPM LCD shows GSM Start.
The test may require a few minutes to complete as the SSPM attempts to connect to the DMS for firmware, configuration, and time
stamp updates.
Note: Do not press any buttons on the keypad until the communications test is complete, as this may interrupt the test session. Press
X Cancel at any time to cancel the communications test, and return to the Diagnostics menu.
83