Installation Guide

REV A

336-0089

The PoE+ injector is designed to provide power via

PoE+ (IEEE 802.3at) and is required if there is no

other PoE+ Switch or power source.

The PoE+ Splitter is designed to provide the necessary

power to the iPad's Lightning or USB - C Connector

from a PoE+ power source. For more detailed

information, see enclosed Diagrams

PoE+ Adapter (72102) (f)

PoE+ Injector (72106) (g)

PoE + Adapter - 72102

PoE + Injector - 72106

PAGE 1
PoE + Adapter - 72102 The PoE+ Splitter is designed to provide the necessary power to the iPad's Lightning or USB - C Connector from a PoE+ power source. For more detailed information, see enclosed Diagrams PoE + Injector - 72106 6 The PoE+ injector is designed to provide power via PoE+ (IEEE 802.3at) and is required if there is no other PoE+ Switch or power source.
PAGE 2
Plug in the provided IPORT USB-C cable directly into the iPad. Position the iPad Face down into the (a) bezel with the iPad cable on the left. Carefully wrap the iPad cable under the retention loop located on the (a) bezel. To lock the iPad in place, use a flat head screwdriver to deploy the second and third toggles located on th right side of the Surface Mount (a) bezel. The first top-right toggle is a power button extension. Connect the USB-C to Molex cable into the (f) PoE Adapter shown.