Product Manual

14
6.3 USING THE 3-BUTTON REMOTE CONTROL
The included remote control(s) is preprogrammed to your MUTT
®
and should never
lose its programming. In the event that you suspect your remote has lost its program-
ming, contact technical support at 888-786-7899 or email [e-mail].
HOW TO PROGRAM THE 3-BUTTON REMOTE
1. Press and hold the On/Off Button while turing on the MUTT
®
.
2. Continue to hold for 2 seconds.
3. Your Remote Control is now programmed.
HOW TO USE THE WIRELESS REMOTE
1. UP ARROW
Press and release to select the next circuit
in clockwise rotation. Press and hold for
5 seconds to activate All Circuits On Mode.
2. DOWN ARROW
Press and release to select the next circuit in a
counterclockwise rotation. Press and hold for
5 seconds to turn on hazard lights.
3. ON/OFF
Press and release to engage/disengage
air brakes.
4. REMOTE CONFIRMATION INDICATOR
Press any of the buttons (1,2,3) and the blue
light (4) will illuminate to confirm the battery
power of the remote.
NOTE: Inclement weather, nearby power transformers and closely parked trailers
may reduce the remote signal.
The supplied, key fob battery for the remote control is 12V, Alkaline Energizer type
A23. A Gold Peak type 23A or Duracell MN21 battery can also be used.
1
4
2
3
3-Button Remote Control
27
For diagnostic and troubleshooting assistance, call Meritor WABCO at 1-800-535-5560
Blink
Code
Problem Area Action
3 Sensor BUI
Determine sensor location. Check sensor installation.
Make necessary repairs.
4 Sensor YEI
Determine sensor location. Check senor installation.
Make necessary repairs.
5 Sensor BU2
Determine sensor location. Check sensor installation.
Make necessary repairs.
6 Sensor YE2
Verify proper electrical modulator installation.
Check power supply. Make necessary corrections.
7 External ABS Modulator Valve
Verify proper electrical modulator installation.
Check power supply. Make necessary corrections.
9
Internal modulator
failure inlet valve #2
Verify proper installation. If code continues, contact
Meritor WABCO for assistance.
10
Internal modulator
failure inlet valve #1
Verify proper installation. If code continues, contact
Meritor WABCO for assistance.
11
Internal modulator
failure inlet valve
Verify proper installation. If code continues, contact
Meritor WABCO for assistance.
14 Power Supply
Verify proper electrical installation. Check power supply. Make
necessary corrections.
15 ECU Failure
Verify proper installation. If code continues, contact Meritor
WABCO for assistance.
16 SAE JI 708 Failure Internal failure, contact Meritor WABCO
17
SAE J2497
(PLC) Failure
Internal failure, contact Meritor WABCO
18 Generic I/O Failure
Verify proper electrical installation. Check power supply. Make
necessary corrections.
9.1 MERITOR/WABCO BLINK CODES
To access Meritor/WABCO blink codes, you must select the Auxiliary Circuit to
power ON/OFF/ON in one second intervals using the following directions:
1. Make sure trailer is stationary and wheels are properly chocked.
2. On the MUTT
®
, turn the control knob to the Auxiliary Circuit. Pause one second.
3. Turn the control knob to the Ground Integrity Indicator (one position to the right).
Pause one second.
4. Turn the control knob back to the Auxiliary Circuit (one position to the left).
5. Count number of blinks on the trailer ABS lamp. Use the chart below for specifi c
fault information.