Product Manual

7.4 ACTIVATING HAZARD LIGHTS:

The four-way ﬂ ashers on the vehicle can be activated manually or with the remote

control.

Manually

1. To activate, set the Hazard Switch to the ON position.

2. To deactivate, set the Hazard Switch to the OFF position.

Remote Control

1. To activate, press and hold the DOWN ARROW button for 5 seconds.

Set the Hazard Switch to the ON Position

Set the Hazard Switch to the OFF Position

Press and Hold DOWN ARROW to Activate

7.5 ALL CIRCUITS ON (OVERRIDE) MODE:

All Circuits On Mode will engage all electrical circuits at the same time. While short

circuit sensing is operational in this mode, if a short circuit is found, the MUTT

will

not be able to identify which circuit is the cause of the short. Open and crossed

circuits sensing is not operational in this mode.

On trailers using incandescent bulbs, All Circuits On Mode will typically result in an

overload because the amperage draw will exceed the maximum of 20 amps.

All Circuits On Mode can be accessed manually or by remote control.

MANUALLY

1. To activate, press and hold control knob for 10 seconds. Listen for beep, then release.

2. To cancel, press or turn the control knob.

NOTE: Does not work when ABS or Brake Light Circuits are selected.

REMOTE CONTROL

1. To activate All Circuits On Mode press and hold UP ARROW for 5 seconds and

then release.

2. To cancel, press and release either arrow.

Press and Hold UP ARROW to Activate

Press and Hold Control Knob to Activate