Product Manual

BATTERY GASES, TESTER PREPARATION

AND TESTER/CHARGER LOCATION

RISK OF EXPLOSION

• Gases produced by a battery are highly explosive.

• Wear safety goggles and protective clothing, both

users and bystanders.

• Use in an area having at least four air changes per hour.

• Read, understand and follow all instructions for charger, battery, vehicle and any

equipment used near battery and charger.

• Do not smoke, strike a match, place metal tools on battery or cause a spark in

the vicinity of the battery. When removing battery cables, remove the ground

cable rst.

• Clean terminals before charging battery. During cleaning, keep corrosive particles

from eyes, nose and mouth. Use baking soda and water to neutralize acid and

help eliminate airborne corrosion.

• Never allow clamps on charger cables to touch each other.

• Do not expose tester or charger to rain, snow, or wet conditions.

• Do not allow battery gases or acid to contact MUTT

cabinet. Do not place

charger directly above or below battery.

• Fill battery to level specied by battery manufacturer using distilled water.

• Do not remove cell caps while charging per manufacturer’s instructions.

• Make sure tester cable clamps make tight connections.

• Battery explosion can cause injury.