Product Manual

1st
Digit
2nd
Digit
Fault Description Repair Information J1587
(SID)
J1587
(FMI)
10 10 No Faults ABS system fully operational - no
faults detected.
1 0
2
3
4
5
2
3
4
5
2
3
4
5
1
1
1
1
2
2
2
2
3
3
3
3
SL Sensor signal valid -large gap
SR Sensor signal valid - large air gap
SAL Sensor signal valid - large air gap
SAR Sensor signal valid - large air gap
SL Sensor signal valid - loss of signal
SR Sensor signal valid - loss of signal
SAL Sensor signal valid - loss of signal
SAR Sensor signal valid - loss of signal
SL Sensor signal valid – noisy
SR Sensor signal valid – noisy
SAL Sensor signal valid – noisy
SAR Sensor signal valid – noisy
Dynamic Wheel Speed Sensor Fault.
1
2
3
4
1
2
3
4
1
2
3
4
0
0
0
0
1
1
1
1
2
2
2
2
2
3
4
5
4
4
4
4
SL Sensor shorted or open
SR Sensor shorted or open
SAL Sensor shorted or open
SAR Sensor shorted or open
Static Wheel Speed Sensor Fault.
1
2
3
4
4 or 5
4 or 5
4 or 5
4 or 5
2
3
4
5
5
5
5
5
SL Tire diameter out of range
SR Tire diameter out of range
SAL Tire diameter out of range
SAR Tire diameter out of range
Verify correct tire size as desired.
Verify proper tire ination.
Verify correct number of excitering
teeth.
Verify that the ECU has the proper tire
size settings.
1
2
3
4
13
13
13
13
WHEEL SPEED SENSORS (WSS)
9.3 BENDIX BLINK CODES
To access Bendix Blink Codes you must select the Auxiliary Circuit and press the
control knob to cycle the Brake Light Circuit the appropriate number of times using
the following directions:
See table below for modes and sequences:
1. Make sure trailer is stationary and wheels are properly chocked.
2. On the MUTT®, turn the control knob to select the Auxiliary Circuit
3. Push the control knob to cycle the Brake Light Circuit for each desired Cycle in
one second intervals. The Brake Light Circuit will ash.
4. Count number of blinks on Trailer ABS Lamp; see chart below for specic fault info.
NOTE: Blink code “Digits” are separated by a one second pause.
Mode Cycle Brake Light Power
Display Active DTCs 3 times
Display Inactive DTCs 4 times
Clear Active DTCs 5 times
Display Conguration 6 times
Display Odometer Mileage 7 times
Reset Conguration 8 times
30