Product Manual

10
PART 4: SETUP
BATTERY REQUIREMENTS/INSTALLATION
CHOOSING A BATTERY
(Manufacturer’s Suggested Replacement: YUASA #YTX14 or Group 14 Equivalent)
• Battery Voltage: 12/24V DC
• Battery Type: Lead-Acid
• Battery Compartment Dimensions: 5 7/8" L x 5 3/4" H x 3 3/8" W
• Battery Protection: In-line 30 amp Fuse for Overcharge
INSTALLING AN INTERNAL BATTERY
1. Remove the four 8/32" x 1/4" Phillips head screws in
the back of the MUTT®.
2. Slide out the battery tray.
3. Place the battery onto the tray with the battery terminals facing the front of the
unit. Attach the ring terminal on the red wire to the positive side of the battery and
tighten securely.
4. Cover positive terminal with the red boot.
5. Attach the ring terminal of the black wire to the negative battery terminal.
6. Carefully slide the tray into the tester. Use caution – DO NOT ALLOW the positive
battery terminal to contact the unit.
7. Reinstall screws to secure.
DO NOT
Use 24 Volts on a Trailer
Wired for 12 Volts!