Product Manual

15
7.4 ACTIVATING HAZARD LIGHTS
The four-way fl ashers on the trailer can be activated with the 3-Button Remote Control.
3-Button Remote Control
1. To activate, press and hold the DOWN ARROW button for fi ve seconds.
7.5 ALL CIRCUITS ON (OVERRIDE) MODE
All Circuits On Mode will engage all electrical circuits at the same time. While short
circuit sensing is operational in this mode, if a short circuit is found, the MUTT
®
will
not be able to identify which circuit is the cause of the short. Open and crossed
circuits sensing is not operational in this mode.
On trailers using incandescent bulbs, All Circuits On Mode will typically result in an
overload because the amperage draw will exceed the maximum of 20 amps.
All Circuits On Mode can be accessed manually or by remote control.
MANUALLY
1. To activate, press and hold control knob for ten seconds. Listen for beep, then release.
2. To cancel, press or turn the control knob.
NOTE: Does not work when ABS or Brake Light Circuits are selected.
Press and Hold DOWN ARROW to Activate
Press and Hold Control Knob to Activate
4
BATTERY GASES, TESTER PREPARATION
AND TESTER/CHARGER LOCATION
RISK OF EXPLOSION
• Gases produced by a battery are highly explosive.
• Wear safety goggles and protective clothing, both
users and bystanders.
• Use in an area having at least four air changes per hour.
• Read, understand and follow all instructions for charger, battery, vehicle and any
equipment used near battery and charger.
• Do not smoke, strike a match, place metal tools on battery or cause a spark in
the vicinity of the battery. When removing battery cables, remove the ground
cable fi rst.
• Clean terminals before charging battery. During cleaning, keep corrosive particles
from eyes, nose and mouth. Use baking soda and water to neutralize acid and
help eliminate airborne corrosion.
• Never allow clamps on charger cables to touch each other.
• Do not expose tester or charger to rain, snow or wet conditions.
• Do not allow battery gases or acid to contact MUTT
®
cabinet. Do not place
charger directly above or below battery.
• Fill battery to level specifi ed by battery manufacturer using distilled water.
• Do not remove cell caps while charging per manufacturer’s instructions.
• Make sure tester cable clamps make tight connections.
• Battery explosion can cause injury.