mac

Commands for Layer 3 Management
275
address cannot be set as neighbor.
Example: Set static neighbor 2001:1:2::4 on port E1/1, and the hardware MAC address
is 00-03-0f-89-44-bc.
Switch(Config-if-Vlan1)#ipv6 neighbor 2001:1:2::4 00-03-0f-89-44-bc interface Ethernet
1/1
21.2.25 show ip interface
Command: show ip interface [<ifname> | vlan <vlan-id>] brief
Function: Show the brief information of the configured layer 3 interface.
Parameters: <ifname> Interface name; <vlan-id> VLAN ID.
Default: Show all brief information of the configured layer 3 interface when no parameter
is specified.
Command mode: All modes.
Usage Guide: None.
Example:
Restarter#show ip interface vlan1 brief
Index Interface IP-Address Protocol
3001 Vlan1 192.168.2.11 up
21.2.26 show ip traffic
Command: show ip traffic
Function: Display statistics for IP packets.
Command mode: Admin Mode
Usage Guide: Display statistics for IP, ICMP, TCP, UDP packets received/sent.
Example:
Switch#show ip traffic
IP statistics:
Rcvd: 3249810 total, 3180 local destination
0 header errors, 0 address errors
0 unknown protocol, 0 discards
Frags: 0 reassembled, 0 timeouts
0 fragment rcvd, 0 fragment dropped
0 fragmented, 0 couldn't fragment, 0 fragment sent
Sent: 0 generated, 3230439 forwarded
0 dropped, 0 no route
ICMP statistics:
Rcvd: 0 total 0 errors 0 time exceeded