User's Manual

SECTION 4: FACTORY TEST PROCEDURE
703800.DOC Page 29
Programming and Configuring Mobile Radio
Once the appropriate equipment for performing the factory test are gathered, perform the following steps
to program and configure an M64800D25 Mobile Radio:
Step 1 Enter the mobile radio serial number, date test being performed, and tester’s name on the
Test Data Sheet (see Appendix B).
Step 2 Program the radio to the current Firmware revision using the AVR programming utility.
Step 3 Connect a PC to the radio and launch the IPMessage program. In the IPMessage window,
type factory default, press [ENTER], and the radio displays the radio’s default values.
Step 4 Enter the appropriate values for the radio's frequency band. The following values were used
for an 806 to 824 MHz mobile radio: