User's Manual

SECTION 2: SETUP AND CONFIGURATION METHODS

516.80548.POM_REVA_Product_Owner's_Manual_M64780D25_FCCRpt.doc Page 6 of 44

ECN-5277

High Speed Mobile Radio Setup Scenarios

The following section describes the setup methods for high speed mobile radio in a vehicle. The two (2)

possible configurations consist of the following:

1. Mobile Radio-to-Mobile Computer

2. Mobile Radio-to-VIU-to-Mobile Computer

Mobile Radio-to-Mobile Computer Setup

Figure 3: High Speed Mobile Radio-to-Mobile Computer Setup

Additional components are required to setup a high speed mobile radio-to-mobile computer configuration,

and are listed below in Table 2:

TABLE 2: HIGH SPEED MOBILE RADIO-TO-MOBLE COMPUTER COMPONENTS

REQUIRED FOR INSTALLATION

QTY DESCRIPTION

1 IPSeries High Speed Mobile Radio

1 Mobile Computer

1 20-foot serial cable (DB9F – DB9M)

1 IPMobileNet SLIP Port Driver Installation Diskette (SLIP2IPMN.exe)



If using the high speed mobile radio’s Ethernet feature an Ethernet crossover cable is required to

replace the 20-foot serial cable.

To configure the high speed mobile radio and computer for this type of setup, follow the

instructions on pages 2 through 17 in the Mobile Computer Setup for Communication with the

Mobile Radio Installation Guide (IPMN p/n: 516.80310.IG) available on the Product

Documentation CD.