Installation Guide

MDCMR-Guide.doc\4-Sep-03 Page 6 of 20
Modem Settings
Step 1 On the IPMobileNet Diversity Radio Network, Fast
Properties window, under the General tab, make sure
that the Maximum speed is set to 115200.
Click on the Connection tab.
For Windows 2000 & XP
, click on the Advanced tab. Click on the
Change Default Preferences... button and then on the Advanced
button and continue to Step 2.
Step 2 Under the Connection tab, ensure that the following
settings are selected:
• Data bits: 8
Parity: None Stop bit: 1
Click on the Port Settings... button.
For Windows 2000 & XP, after verifying the Connection
preferences, click on the OK button three (3) times and close the
windows by clicking on the ⌧ in the upper right-hand corner of the
windows. Go to the ‘SLIP2IPMN Dial-up Network Settings’ for
Windows 2000 section on page 10 of this document.
For Windows NT
, skip to Step 4 on this page.
For Windows XP
, skip to Page 16.
Step 3 On the Advanced Port Settings window, select Use F
IFO
buffers (requires 16550 compatible UART).
The Receive Buffer
should be set to High
approximately on the third notch, as shown
above.
The Transmit Buffer
needs to be set higher
than the Receive Buffer on the last notch as
shown above or to Maximum.
Click on the OK button.
Step 4 Under the Connection tab, click on the Advanced...
button.
Select the Use f
low control and Hardware (RTS/CTS),
then click on the OK button, click on OK again, then click
on the Close button.
The Control Panel Window will display.
Close the Control Panel window.
For Windows NT
, at the Modem Properties window, click on the
Close button and go to ‘SLIP2IPMN Dial-up Network Settings’ for
Windows NT on page 13.