Installation Manual
Table Of Contents
- IPSeries Mobile Radio User Manual
- Document Revision Control
- Table of Contents
- Manual Components
- Chapter 1: Introduction
- Chapter 2: Basic Network Configuration
- Chapter 3: Setup and Configuration Scenarios
- Chapter 4: Production Installation
- Installation Overview
- Installation Instructions
- Post Installation Checklist
- Preliminary Testing and Troubleshooting
- Preliminary Test Procedure and Troubleshooting
- Chapter 5: Programming Instructions
CHAPTER 4: PRODUCT INSTALLATION
2003 IPMobileNet, Inc. 34 IPSeries MR User Manual / Rev. A / 08-Apr-03
Base Station Setup for Testing
The system must be programmed with the customer’s parameters before any tests are made on
the mobile radio.
To prepare the base station to be used in the mobile radio test, perform the following steps:
Step 1 On the laptop at the Windows desktop, click on the Start button and select
Accessories, Communications, and HyperTerminal.
Step 2 Power up the base station.
First-time users must enter the customer’s operating parameters into the base station
with HyperTerminal (refer to the IPB Base Station System Manual for instructions,
and the client’s system documentation for parameters).
1 Ensure that the calibrated base station and the mobile radio antennas are separated
by at least 10 feet. If the antennas are too close, the mobile radio receivers may
overload by the transmitters resulting in intermittent communications and high data
errors.