User Guide
Table Of Contents
- Mobile Radio System Installation Guide
- Mobile Radio Illustration
- Installation Overview
- Installation Instructions
- Pre-Installation Guidelines
- Mounting the Mobile Radio
- Serial Cable Connection and Routing
- EMI Filter Installation
- Radio Power Supply Installation
- MDC Power Supply Installation
- Carling Switch Installation (DPST Heavy Duty Toggle)
- Delay Timer Installation
- Antenna Installation
- VIU Connections
- Mobile Radio Testing
- Installation Checklist
- Vehicle Unit Wiring Interconnection Layout
- Mobile Antenna Distance Matrix
- Diversity Antenna Mobile Installation Detail (Typical Install)
- Vehicle Unit Wiring Interconnection Layout (with VIU)
- Vehicle Unit Wiring Interconnection Layout (Data 911 with VIU)
~\Technical Documentation\Install_Guides\MR-Guide\2-May-02 Page 10 of 15
Installation Checklist
Throughout the installation process and once the
installation is complete, make sure to perform the
following tasks:
Thoroughly scope out the vehicle to find any obvious problem
areas.
Check wiring for safety concerns.
Use tie wraps to ensure that all wires routed in parallel are
bundled together.
Check to see if any wires are exposed.
If any wires are exposed, use electrical tape to cover.
REMINDER
: When covering wires in the engine compartment,
use high-quality electrical tape.
Perform appropriate testing as described in this guide to
ensure radio works properly.
Once installation is completed, remove all debris and restore
dismantled parts and rubber mats to appropriate locations.