User's Manual

CHAPTER 5: PROGRAMMING INSTRUCTIONS
2003 IPMobileNet, Inc. 30 IPSeries MR User Manual / Rev. A / 04-September-03
Factory Default Save and Restore
For instructions on Factory Default Save and Restore Commands, please contact the Customer Service
number provided in Chapter 6 of this document.
Additional Programming Needs
Refer to the following technical notes and programming instructions and select the appropriate document
for additional programming needs.
TABLE #_: ADDITIONAL PROGRAMMING DOCUMENTS
TN01-011
Base Station Setup for Programming using an F167 Processor
This technical note provides instructions for establishing a connection that
allows programming of a Base Station using an F167 processor.
TN01-0012
Base Station Setup for Programming using an F168 Processor
This technical note provides instructions for establishing a connection that
allows programming of a Base Station using an F168 processor.
TN01-0020
Remote Firmware Updates for the IPNC and Base Station
This technical note provides instructions on how to perform remote Firmware
updates for the IPNetwork Controller and IPSeries base stations.
TS.0004-PI
Black Box Terminal Server
This programming instruction provides instructions on how to configure terminal
server Firmware when used to interface with a base station.