User's Manual

F32700N25.doc Page 12

Ceramic tuning tool

IPMN p/n:

44010006

1 ea

#0, #1, and #2 Phillips

screwdrivers (generic)

Programming and Configuring the Fixed Radio

Once the appropriate equipment for performing the factory test is gathered, perform the

following steps to program and configure an F32700N25 Fixed Radio:

Step 1 Enter the following information on the Test Data Sheet (see Appendix B):

 Radio Serial number

 Date test being performed

 Tester's Name

Step2 Connect the power cable with a voltage source of 13.8vDC able to deliver 5

amps continuous and apply power to the mobile radio.

Step 3 Program the radio to the current Firmware revision using the AVR

programming utility.

Step 3 Program the radio to the current Firmware revision using the AVR

programming utility.

Step 4 Connect a PC to the radio and launch the IPMessage program. In the

IPMessage window, and verify the IP Message connection using the “?”

command.

Step 5 The radio will need to be unlocked using the command “Unlock=Password”

using the appropriate password and placed into testmode using the command

“testmode=1” for all tests unless specified otherwise.

Step 6 Type „pll type=Analog Devices”.

Step 7 Enter the appropriate values for the radio's frequency band. The following

values were used for the fixed radio:

[From: 172.16.64.1] Host serial = 115200,N,8,1, timeout=200

[From: 172.16.64.1] Channel = 0

[From: 172.16.64.1] Channel Tx freq Rx freq

Inj freq