User's Manual

Code: Installation Guide EZPRO25 RF.d
o
INSTALLATION
GUIDE
Date: 12/18/2007 Page: 6 of 21
Initial Release
Revision: 00
These standards ensure the essential requirements established in article 3 of directive
1999/5/CE.
In any case, take the following points into consideration:
 Most electronic equipment is susceptible to electromagnetic interference if it is not
duly protected. If the EZPRO25 RF is placed near unprotected electronic devices,
they may malfunction.
 The EZPRO25 RF must not transmit without its antenna connected or, in case of the
EZPRO25 RF, without the 50Ω load in the TNC connector.
 When installing the antenna, follow the guidelines for exposure of the human body to
high and low frequency electromagnetic fields. Follow the supplier’s / manufacturer’s
instructions.
 Burns may be suffered if the antenna connector output of the power module (RPA
P25) is touched by bare skin when the EZPRO25 RF are transmitting with the
antenna disconnected.
 Take care when handling the EZPRO25 RF. It has sharp edges, which may cut if
handled incorrectly.
 Maintenance and repair of these repeaters must be carried out by qualified personnel
only.
 Connect the EZPRO25 RF chassis to the earth intake in the cabinet where it is to be
installed.
 Switch off the EZPRO25 RF before inserting/removing any of its modules.
!