User's Manual

CHAPTER 2: INSTALLATION INSTRUCTIONS
489287.DOC Page 10
Single Base Station Configuration
Figure 5: Base Station Ethernet Connection
NOTE
: The base station shown in the figure only displays Ethernet connectivity and is not
display the actual 700 MHz base station.
To connect a single base station, perform the following steps:
Step 1 Plug in the Ethernet crossover cable into the Ethernet port on the base station (as
shown in the figure above).
Step 2 Route and plug in the other end of the Ethernet crossover cable to an IPMobileNet’s
Internet Protocol Network Controller (IPNC) via the hardware as defined by the
organization’s configuration.

If connecting to a Serial backhaul, an IPMobileNet IPTurbo Converter is required.
For connection instructions, refer to the IPTurbo Converter Quick Reference Guide
(IPMN p/n: 516.80496.QR) available on the Product Documentation CD provided with
this product.
Multiple Base Station Configurations
To connect multiple base stations, perform the following steps:
Step 1 Plug in the Ethernet cables to the back of each base station (as shown in the figure
above) and route according to selected setup. Refer to the IPTurbo Converter Quick
Reference Guide (IPMN p/n: 516.80496.QR) for setup instructions and scenarios.
Step 2 Route and plug in the Ethernet cables to an IPMobileNet’s Internet Protocol Network
Controller (IPNC) via the hardware as defined by the organization’s configuration.