User's Manual

SECTION 2: FACTORY TEST PROCEDURE
401855 Page 12
Equipment List
The following table lists the equipment required to perform the B32450-25 Base Station Factory Test
Procedure.
CHECKLIST OF REQUIRED MATERIAL FOR
PRELIMINARY TESTING OF THE IPSeries BASE STATION
NO. REQUIRED TOOLS
;
1
Calibrated Base Station System – Consisting of the following components:
(1) Appropriate version IPSeries Base Station to be tested
(2) Desktop or laptop computer configured as an Internet Protocol Network Controller (IPNC)
(3) Corresponding IPSeries Mobile Radio (If an B32450-25 base, use M32450-25 mobile)
(4) Desktop or laptop computer with two (2) available serial ports and Microsoft Windows 95 or
greater and IPMobileNet Dial-Up Networking, IPMessage software (SLIP2IPMN.exe), and
HyperTerminal for base station installed

2
Comm Test Set (HP 8920A or B)

3
High Frequency Probe (85024A)

4
Power Supply for 85024A Probe (HP1122A)

5
Four (4) Channel Scope (Tektronix TDS 460A)

6
General Purpose Scope Probe

7
Digital multi-meter Tektronix Fluke (DMM912 77)

8
DC power supply with ammeter, 13.8V, 12 amps or more (Astron VS12M or equivalent)

9
100-watt dummy load/attenuator (Pasternack PE7021-40 or equivalent)

10
Four (4) antennas (generic mag mounts) tuned to frequency or transceiver

11
Serial cable DB9M – DB9F connectors (generic)

12
Input/Output (I/O) Board (IPMN p/n: 502-80081)

13
IPSeries Base Station power cable specified for use with the specific base station being used

14
Three (3) serial DB9F-DB9M Null Modem cables
