Installation Instructions

© ip.access Ltd
COMPANY CONFIDENTIAL 110#010XA_GDE.doc
- 37 -
Communication Problems
No LEDs
Check that the BTS is connected to the Ethernet cable
and ensure it is plugged in fully into the Ethernet
socket.
Check that the Ethernet cable is plugged into a power
supply.
Check that the Ethernet is plugged into the correct
socket on the power supply (BTS).
LED’s have been disabled using nanoInstaller
Does the BTS have Power?
Check that the power supply is connected to the
mains and powered up.
LED is on but is flashing orange (1sec on, 1sec off)
Check the Ethernet cable between power supply unit
and installation PC.
Check that the cable between PC and Power supply
unit is crossed, if connecting directly to the nanoBTS
Check that the Ethernet is connected to a correct
(Live) socket on the hub.
The unit is powered up but
does it have proper
connection to the installation
PC.
Check that the DHCP server is running on installation
PC
No communication between the nanoInstaller and the BTS
Check that nanoInstaller is not set to look at the wrong
IP address or port number
Check that the Ethernet cable is connected between
the installation PC and the BTS via the power supply
box.