Installation Instructions

© ip.access Ltd
COMPANY CONFIDENTIAL 110#010XA_GDE.doc
- 36 -
Appendix 5 Troubleshooting
Checking that the nanoBTS has successfully downloaded an IP
address
Start the program 'Bts Finder' select the IP address and MAC address boxes and
click the Find BTS button.
Figure 34 Bts Finder Opening Screen
Check that the IP address and MAC address are as required.
Figure 35 Find BTS Results
Resetting the nanoBTS to factory default settings.
1. Remove the connecting cable providing power to the nanoBTS.
2. Insert the dongle into the "TIB IN" port.
3. Power ON the unit by reconnecting the Ethernet cable to the nanoBTS.
4. Wait until the LED shows fast blinking red (0.3 seconds on and 0.1 seconds off)
5. Remove the dongle.
6. Reboot the unit by removing the Ethernet power cable, waiting 10 seconds and then
reconnect the Ethernet cable.