Installation Instructions
© ip.access Ltd
COMPANY CONFIDENTIAL 110#010XA_GDE.doc
- 28 -
Appendix 1: Modifying nanoBTS for use with external antenna
Remove Plastic cover.
Remove the top and bottom plates from both ends of the nanoBTS. Lever gently apart with
screwdriver in notch.
Antenna Cover
Top
Antenna Cover
Bottom
Notch to aid
removal of
cover
Antenna Cover
Body
Figure 24 Removal of antenna covers
Remove the antenna cover body, by unscrewing the two Torx T20 screws retaining
Remove Torx Screws
Figure 25 Removal of antenna cover body
Fit the replacement antenna cover body ensuring that the feeder cable connector fits into
the antenna. Note that one cover only fits the receiver whilst the other fits the transmitter.
Fit the clamp as shown below and second Torx screw, then replace top and bottom covers.