Installation Instructions

COMPANY CONFIDENTIAL 110#010XA_GDE.doc

- 12 -

Installing the PSU at the nanoBTS.

Ensure that the PSU is placed in a location that is ventilated and that the connection leads

provide no safety hazard.

RJ45

Connection to LAN

PSU

48Vdc

110-230Vac

Connection to nanoBTS

Mounting the nanoBTS.

The location of each nanoBTS is shown on the installation floor plan produced at the

network planning stage. The network wiring must be complete before the nanoBTS can

be tested. The nanoBTS should be placed on a wall at or above head height or on a

ceiling.

Note: If the nanoBTS is to be used with an external antenna the nanoBTS should be

modified as shown in appendix 1

before mounting the nanoBTS

a) Fixing to a wall

1) Remove the nanoBTS from the bracket by sliding the removal tool over the central fin

between the bracket and the body of the unit to disengage the locking spring, slide

bracket to separate it from the main body of the unit. The tool may be inserted from

the top or bottom of the nanoBTS

nanoBTS bracket removal tool

Slide tool over

centre vane of

nanoBTS

Figure 5 Separating nanoBTS and mounting bracket