Product Description

nanoBTS Product Description Customer safety and regulatory information

8 CUSTOMER SAFETY AND REGULATORY INFORMATION

8.1 Introduction

8.1.1 Purpose and Scope

This section provides the customer with safety and regulatory warnings, cautions and

information.

Products covered are the model 108, 110, 139, 140, 165 and 178 range of nanoBTSs,

model 109 and 126 power supplies.

8.1.2 Terminology

UL Underwriters Laboratories

FCC Federal Communications Commission

IC Industry Canada

CE European Union

8.2 Model 109 Power Supply

8.2.1 109 - Handbook - Warnings and Cautions

This document is written in English.

Please request a copy in your local language if required.

This product is only intended to power products approved by IP Access.

Ensure that only IP Access products are connected to an Ethernet circuit enabled

for 48V operation. This also applies to outlets remote from the unit.

For indoor use only, output cabling is SELV / LAN for indoor routing only.

Do not cover casing or otherwise impede cooling.

Do not apply power to unit if there is any evidence of condensation.

Do not open casing as mains voltages may be present within the unit.

90 to 264VAC input is via a 2 pin IEC C7 (figure 8) connector. Inlet cable

assembly must carry a suitable local approval (e.g. UL marked for US and

Canadian markets).