Installation Manual

nanoBTS Installation Manual

nanoBTS and PSU Regulatory Information

This product is intended for use in all

Member States of the European Union.

"Hereby, ip.access declares that this Ethernet Power Inserter is in compliance with the

essential requirements and other relevant provisions of Directives 73/23/EEC and

89/336/EEC."

The PSU109 is supplied by Poly-Products Industries, model number ILA1711112.

A copy of regulatory compliance documentation may be obtained in writing from

"IP access Ltd, Building 2020, Cambourne Business Park, Cambourne, Cambridge, CB23

6DW, UK".

5.4 Model 126 Ethernet Switch and Power Inserter

5.4.1 126 - Handbook - Warnings and Cautions

This document is written in English, please request a copy in your local

language if required.

This product is only intended to power products approved by IP Access.

Ensure that only IP Access approved products are connected to an Ethernet

circuit enabled for 48V operation, this also applies to outlets remote from the

unit.

To be located in a restricted access location only (accessible to maintenance

personnel only).

For indoor use only, output cabling is SELV / LAN for indoor routing only.

Do not block ventilation holes or otherwise impede cooling.

Refer to National Engineering Code (USA). Wiring methods must be in

accordance with NEC Article 300.

When rack mounting, secure via front panel plate with 4 bolts and ensure that no

additional load is placed upon the caseworks (e.g. heavy objects on top).

When rack mounting, ensure that the internal rack temperature does not exceed

the rating of this product.