Installation Manual

nanoBTS Installation Manual

nanoBTS and PSU Regulatory Information

5.2.6.4 Safety Standards

• EN60950 (CE Marking)

• IEC 60950

• UL60950 Listed (file number E230296, USA and Canada)

• CB Certificate

This product is intended for use in all

Member States of the European Union.

"Hereby, ip.access declares that this NanoBTS is in compliance with the essential

requirements and other relevant provisions of Directive 1999/5/EC."

A copy of regulatory compliance documentation may be obtained in writing from

"IP access Ltd, Building 2020, Cambourne Business Park, Cambourne, Cambridge, CB23

6DW, UK".

5.3 Model 109 Power Supply

5.3.1 109 - Handbook - Warnings and Cautions

This document is written in English, please request a copy in your local

language if required.

This product is only intended to power products approved by IP Access.

Ensure that only IP Access products are connected to an Ethernet circuit

enabled for 48V operation, this also applies to outlets remote from the unit.

For indoor use only, output cabling is SELV / LAN for indoor routing only.

Do not cover casing or otherwise impede cooling.

Do not apply power to unit if there is any evidence of condensation.

Do not open casing as mains voltages may be present within the unit.

90 to 264VAC input is via a 2 pin IEC C7 (figure 8) connector. Inlet cable

assembly must carry a suitable local approval (e.g. UL marked for US and

Canadian markets).