Installation Manual

nanoBTS Installation Manual

nanoBTS and PSU Regulatory Information

The nanoBTS must only be powered using an ip.access model 109 PSU (PPI

part number ILA1711112) or ip.access model 126 Ethernet switch and power

inserter (unless prior written approval is obtained from IP Access). Model 165

BTS’s may also be powered by a direct 48V connection using a PSU specified in

writing by IP Access Ltd.

PSU’s supplied by ip.access must not be used for powering any other equipment

(unless carried out in a manner having prior written approval from IP Access).

TIB ports on the NanoBTS may only be connected with ip.access supplied

cables with part numbers 139-040, 139-041, 139-042, 139-043 or 165-076.

Fitting external antenna or antenna cabling to the BTS invalidates the type

approval, CE marking and UL listing referred to herein (unless carried out in a

manner having prior written approval from IP Access).

Maximum cable length from the Ethernet Hub, Switch or PSU is limited to 100m.

5.2.2 nanoBTS - Handbook - Parts Required for each nanoBTS

• Wall Fixings: These are not normally provided as part of the nanoBTS but should be

suitable for the wall material and weight of the nanoBTS (2.7kg). Suggested

materials are 4 x 30mm no.10 woodscrews or M5 bolts and wall plugs (if required).

• PSU.

• NanoBTS complete with mounting bracket.

• RJ45-RJ45 connecting leads.

5.2.3 nanoBTS - Handbook - Provision of Power to the nanoBTS

Power for the NanoBTS may be inserted at either the RJ45 outlet or at the output of the

last Ethernet switch/hub/router etc. see figure below.