Installation Manual

nanoBTS Installation Manual

nanoBTS and PSU Regulatory Information

5 NANOBTS AND PSU REGULATORY INFORMATION

This chapter provides the customer with safety and regulatory warnings, cautions and

information for the ip.access Ltd range of products.

Products covered are the model 108, 110, 139, 140, 165 and 178 range of nanoBTSs and

model 109 and 126 power supplies.

5.1 Terminology

UL Underwriters Laboratories

FCC Federal Communications Commission

IC Industry Canada

CE European Union

5.2 nanoBTS Products

5.2.1 nanoBTS - Handbook - Warnings and Cautions

This system is designed to be operated indoors as a fixed system device and

must be located either on or near the ceiling away from the user. It must be

mounted in a manner to ensure that all users and bystanders are kept a

minimum of 20cm away from the integral antennas at all times.

Do not touch or move the antenna(s) while the unit is transmitting or receiving.

Do not hold any component containing a radio such that the antenna is very

close to or touching any exposed parts of the body, especially the face or eyes

while transmitting.

In most parts of the world, regulatory approval(s) are needed before the

nanoBTS is operated.

Do not connect any device other than the nanoBTS to any RJ45 socket that has

been enabled for nanoBTS connection (i.e. 48Vdc operation).

The nanoBTS is intended for dry indoor applications only. If evidence of

condensation is present do not apply power to the nanoBTS.