Installation Manual

nanoBTS Installation Manual
Commission a nanoBTS
© ip.access Ltd Page 33
9. On the NV Attr (2) tab, select the Configure Primary OML List check box.
10. From the Number of Addresses in List drop-down list, select the number
of BSCs. Typically this will be 1. If there is a second BSC configured for
redundancy, select 2.
11. Enter the Primary OML IP Address. This is the IP address of the BSC.
12. If there is a second BSC configured for redundancy, enter the Primary OML IP
Address 2.
13. Select the Configure Location check box.
14. Enter appropriate descriptive text in the Location field.
15. Select the Configure Unit Name check box.
16. Enter appropriate descriptive text in the Unit Name field.
Note: Changes made on the NV Attr (2) tab will be applied to the BTS without a
reset.
17. Click OK. In the BTS Status section, the Unit ID field should be yellow, and the
NV Attributes field should be red.