Installation Manual

nanoBTS Installation Manual

Commission a nanoBTS

5. On the Unit ID tab, enter a unique Site ID. A slave TRX will have the same Site

ID as the master TRX.

6. On the Unit ID tab, enter a TRX ID. For a master TRX, TRX ID is 0. For a slave

TRX, TRX ID is 1, 2 or 3.

7. On the NV Attr (1) tab, select the Enable NV Attr Configuration check

box.

8. To configure a static IP address, select the Configure Flags check box and

set F1, F2 and F3 to ON. To configure a dynamic IP address, do not make these

settings.

Note: Changes made on the NV Attr (1) tab will not be applied to the BTS until it

has been reset.