Installation Manual

nanoBTS Installation Manual

Commission a nanoBTS

4 COMMISSION A NANOBTS

4.1 Configure the nanoBTS

The process for manually configuring the nanoBTS is as follows:

4.1.1 Set the IP Configuration

1. Power up the nanoBTS. This will take approximately 1 minute. The Status

Indicator on the nanoBTS will flash green and red. This indicates that the Unit ID

has not been set (when the nanoBTS has been fully configured the Status

Indicator will slow blink orange).

2. Open BTS Installer.

3. In the BTS Status section, click New to add the new nanoBTS to the BTS

database. The BTS Configuration dialog is displayed.

4. On the BTS tab, enter the MAC Address of the new nanoBTS.

5. On the BTS tab, enter the IP Address of the new nanoBTS.