Installation Manual

nanoBTS Installation Manual
Getting Started with BTS Installer
© ip.access Ltd Page 24
which subversion of 1.5 is used). The J2SE Java Runtime Environment is available, with
installation instructions, from Sun’s Java web-site (http://www.java.sun.com).
3.4.1 Microsoft Windows
3.4.1.1 Pre-Installation Requirements
Local craft terminal for the installation running Windows 2000 SP2 or Windows XP
SP2
CD-ROM drive or Internet connection
Java run time environment version 1.5.0_07 or later
3.4.1.2 Installing the BTS Installer Package
The estimated installation time for the product is 5 minutes.
1. Login to the PC ensuring that you have Administrator privileges.
2. Using Windows Explorer, browse to the directory, either on the CD-ROM or
network drive where the BTS Installer application is located.
3. Double click on the Icon for BTS Installer:
Note: For actual revision levels of each package, please refer to the System
Release Note.
4. Follow the on-screen instructions to complete the installation.
If it is desired to use BTS Installer to make secure (SSL) connections to nanoBTSs then
perform the following additional steps:
5. Install the Aladdin eToken run time environment.
Aladin e-Token RTE requires that the computer is running Windows 2000 SP2 or
Windows XP SP2.
6. Plug the eToken (a hardware device which contains a certificate and private key
for BTS Installer) into a USB port.
3.4.2 Other Platforms
Details of installing BTS Installer on platforms other than Microsoft Windows are beyond
the scope of this document. However in most cases copying the file BtsInstaller.jar to a
suitable directory will be adequate. On platforms other than Windows there is no support
for making SSL connections to the nanoBTS.
3.5 Starting BTS Installer
3.5.1 From Config Manager
BTS Installer can be started from Config Manager, in which case it will be pre-populated
with some nanoBTSs selected in Config Manager and will operate in proxy mode. See
'Starting BTS Installer from Config Manager' in [OPM_300] for details.