Installation Manual

nanoBTS Installation Manual

nanoBTS Hardware Installation

2.7.1 8 Port Powered Ethernet Switch Installation

The 8 port powered Ethernet switch, is a combined power inserter, for use with the

ip.access range of products and a fully functional 10/100 Ethernet switch.

Figure 20 - 8 port powered Ethernet switch

Power to the unit is provided via a 110 – 240 Volt ac mains plug or via a 48 Volt dc plug

and housed in a 1U 19" rack mount case.

2.7.1.1 Mounting The 8 Port Powered Ethernet Switch

The unit is designed to be mounted within a standard 19" rack, and occupies just 1U

height, with all connections accessible from the front panel.

Insert 4 cage nuts in the 19" equipment rack at the height and location that the 8 Port

Powered Ethernet Switch is to be positioned.

Taking care, slide the 8 Port Powered Ethernet Switch into location, holding the switch

steady, then with 4 mounting screws, secure the 8 Port Powered Ethernet Switch into the

rack.

2.7.1.2 Connecting The 8 Port Powered Ethernet Switch

Connect only one of the required power input connectors to the 8 Port Powered Ethernet

Switch, either mains 110/240V AC or 48V DC.

Figure 21 - Supply connections

Once the 8 Port Powered Ethernet Switch is mounted and the mains AC / DC supply is

connected, the main network can be connected, as shown in Figure 22. When powered

from the mains AC, ensure the unit is earthed via the IEC power cord. When powered from

a 48V DC supply, ensure the unit is earthed via a cable to the screw terminal.

Mains 110-240V AC

48V DC