Installation Manual

nanoBTS Installation Manual

nanoBTS Hardware Installation

Figure 12 - nanoBTS bracket removal

Position the bracket on the wall and mark the position of the four screw holes. The top of

the bracket MUST be positioned uppermost. Ensure that the bracket is level and sufficient

clearance is maintained to allow the unit to be located on the bracket (at least 80mm from

the bracket to the top of wall, and 120mm from the side of the bracket to a side wall). See

Figure 13.

Figure 13 - Fixing the wall bracket

Drill the four holes in the positions marked previously and insert wall plugs (if required) and

fix the mounting bracket securely to the wall. The bracket is designed to allow the

nanoBTS unit to be mounted with the connections either at the top or at the bottom of the

unit.

Slide the nanoBTS onto the bracket and ensure that the retaining spring engages into the

indent at the rear of the unit.