Installation Manual

nanoBTS Installation Manual

nanoBTS Hardware Installation

Figure 10 - Chassis bond screw location - 139/140 nanoBTS

Connect the other end of the Chassis Bond lead to the next nanoBTS chassis bond point

in the chain.

Figure 11 - Chassis bond screw location - 165 nanoBTS

2.5.6 Mounting the nanoBTS

The location of each nanoBTS is shown on the installation floor plan produced at the

network planning stage. For example, it must take into account that all BTSs must be at

least 2m from any mobile equipment. The network wiring must be complete before the

nanoBTS can be installed and commissioned. The nanoBTS should be placed on a wall

(at or above head height) or on a ceiling. Unless explicitly stated otherwise, the following

procedure is common for both 139/140 and 165 hardware variants.

Remove the nanoBTS from the bracket by sliding the removal tool over the central fin

between the bracket and the body of the unit to disengage the locking spring, slide bracket

to separate it from the main body of the unit. The tool may be inserted from the top or

bottom of the nanoBTS.

Chassis

Bond Point