Installation Instructions
Table Of Contents
- nanoBTS Installation and Test Manual
- 1 Introduction
- 2 Overview
- 3 Customer safety and regulatory information (CENG0133)
- 4 BTS Hardware Installation (CENG0210)
- 5 PSU Installation Guide (CENG0033)
- 6 BTS Installer User Guide (CENG0048)
- Introduction
- 6.2 Capabilities
- 6.3 Concepts
- 6.4 Getting Started
- 6.5 User Interface Reference
- 6.6 The DHCP Server
- 6.7 BTS Attribute Reference
- 6.7.1 The BTS Configuration Dialog box
- 6.7.2 Current Values Display
- 6.7.3 Identifying a nanoBTS
- 6.7.4 How Defaults Work
- 6.7.5 Enabling Configuration Phases
- 6.7.6 The BTS tab
- 6.7.7 The DHCP tab
- 6.7.8 The Unit ID tab
- 6.7.9 The NV Attr (1) tab
- 6.7.10 The NV Attr (2) tab
- 6.7.11 The NV Attr (3) tab
- 6.7.12 The NV Attr (4) tab
- 6.7.13 The Download tab
- 6.8 Using Network Listen
- 6.9 Using BTS Installer via a proxy
- 6.10 Connecting to a nanoBTS via SSL
- 6.11 Configuration File Reference
© ip.access Ltd
COMPANY CONFIDENTIAL CENG0336_XE_nanoBTS_Installation_and_Test_Manual.doc
- 92 -
Attribute Description
Configure Location Whether to send a new value for the Location to the
nanoBTS.
Location A text string that can be used to describe the physical
location of the nanoBTS. This string will be recovered
during the Find operation described in section 6.5.4.2.1.
Configure Unit Name Whether to send a new value for the Unit Name to the
nanoBTS.
Unit Name A text string that is used as the nanoBTS’ DNS host
name.
6.7.11 The NV Attr (3) tab
The NV Attr (3) tab, Figure 52, contains additional non-volatile attribute settings. All the
controls on this tab are disabled unless the Enable NV Attr Configuration check box
on the NV Attr (1) tab is checked.
Figure 52 - NV Attr (3) tab
This tab contains the SNMP settings. There is an overall enabling check box,
Configure SNMP Properties, to say whether any of the SNMP configuration should
be sent to the nanoBTS, and if that is checked there are separate check boxes to
control the sending of each individual part of the SNMP configuration. (Again, this
reflects the options available in the underlying GSM 12.21 protocol.)
Attribute Description
Configure SNMP Properties Whether to send new values for any of the SNMP
attributes to the nanoBTS. If this is not checked all the
rest of the attributes on this tab are disabled.