Installation Instructions
Table Of Contents
- nanoBTS Installation and Test Manual
- 1 Introduction
- 2 Overview
- 3 Customer safety and regulatory information (CENG0133)
- 4 BTS Hardware Installation (CENG0210)
- 5 PSU Installation Guide (CENG0033)
- 6 BTS Installer User Guide (CENG0048)
- Introduction
- 6.2 Capabilities
- 6.3 Concepts
- 6.4 Getting Started
- 6.5 User Interface Reference
- 6.6 The DHCP Server
- 6.7 BTS Attribute Reference
- 6.7.1 The BTS Configuration Dialog box
- 6.7.2 Current Values Display
- 6.7.3 Identifying a nanoBTS
- 6.7.4 How Defaults Work
- 6.7.5 Enabling Configuration Phases
- 6.7.6 The BTS tab
- 6.7.7 The DHCP tab
- 6.7.8 The Unit ID tab
- 6.7.9 The NV Attr (1) tab
- 6.7.10 The NV Attr (2) tab
- 6.7.11 The NV Attr (3) tab
- 6.7.12 The NV Attr (4) tab
- 6.7.13 The Download tab
- 6.8 Using Network Listen
- 6.9 Using BTS Installer via a proxy
- 6.10 Connecting to a nanoBTS via SSL
- 6.11 Configuration File Reference
© ip.access Ltd
COMPANY CONFIDENTIAL CENG0336_XE_nanoBTS_Installation_and_Test_Manual.doc
- 88 -
6.7.9 The NV Attr (1) tab
The NV Attr (1) tab, Figure 50, enables or disables the entire non-volatile attribute
setting configuration phase and contains the settings for the Non-volatile Configuration
Flags.
Figure 50 - NV Attr (1) tab
Attribute Description
Enable NV Attr
Configuration
Enables or disables the NV attribute configuration
phase; when disabled all the NV Attr tabs are white and
the remaining attribute controls on these tabs are
disabled.
Configure Flags Whether to send new values for the NV Configuration
Flags to the nanoBTS
F1 to F14 For each flag the user can choose “Not Set”, in which
case the value of this flag on the nanoBTS will be
unchanged, or “OFF” to switch this flag off on the
nanoBTS or “ON” to switch this flag on on the
nanoBTS.
See table below for the meaning of each flag.
Flags that are missing from the numerical sequence are not currently used, except for
F4 which is automatically generated by BTS Installer for the benefit of older nanoBTS
software that needs a value for this flag.