Installation Instructions
Table Of Contents
- nanoBTS Installation and Test Manual
- 1 Introduction
- 2 Overview
- 3 Customer safety and regulatory information (CENG0133)
- 4 BTS Hardware Installation (CENG0210)
- 5 PSU Installation Guide (CENG0033)
- 6 BTS Installer User Guide (CENG0048)
- Introduction
- 6.2 Capabilities
- 6.3 Concepts
- 6.4 Getting Started
- 6.5 User Interface Reference
- 6.6 The DHCP Server
- 6.7 BTS Attribute Reference
- 6.7.1 The BTS Configuration Dialog box
- 6.7.2 Current Values Display
- 6.7.3 Identifying a nanoBTS
- 6.7.4 How Defaults Work
- 6.7.5 Enabling Configuration Phases
- 6.7.6 The BTS tab
- 6.7.7 The DHCP tab
- 6.7.8 The Unit ID tab
- 6.7.9 The NV Attr (1) tab
- 6.7.10 The NV Attr (2) tab
- 6.7.11 The NV Attr (3) tab
- 6.7.12 The NV Attr (4) tab
- 6.7.13 The Download tab
- 6.8 Using Network Listen
- 6.9 Using BTS Installer via a proxy
- 6.10 Connecting to a nanoBTS via SSL
- 6.11 Configuration File Reference
© ip.access Ltd
COMPANY CONFIDENTIAL CENG0336_XE_nanoBTS_Installation_and_Test_Manual.doc
- 75 -
Note that as for some other non-volatile (NV) attributes there are two versions of the
SSL Control attribute on the nanoBTS – the “NV” version, which says what the
nanoBTS will do next time it is reset, and the “current” version, which says what it is
doing now. BTS Installer displays the current version. If the value of SSL Control is
changed by some means, for example by using Config Manager, but the nanoBTS is
not reset then there will be no change to the value of SSL Control displayed on this
dialog until after the nanoBTS has been reset.
The Manufacturer Serial Number of the nanoBTS is displayed. This is used in working
out the name of the certificate .sdp file which BTS Installer will attempt to locate in the
.zip file which the user has specified on the Download tab of the BTS Configuration
dialog. If the .zip file does not contain a certificate for this individual nanoBTS then it is
this serial number that should be used, via whatever administrative procedures are in
place, to locate or request the certificate for the nanoBTS.
If a Certificate Revocation List has ever been downloaded to the nanoBTS then its
timestamp is displayed. BTS Installer will refuse to download a certificate revocation
list to the nanoBTS unless it has a later timestamp than the one already in the
nanoBTS.
The Certificate Download Status displays the results of several checks that BTS
Installer has performed on the .zip file specified by the user on the Download tab of the
BTS Configuration dialog. This includes checking that the .zip file does contain a
certificate for the nanoBTS as determined by its Manufacturer Serial Number.
If the certificate file appears valid, the Download Certificate button is enabled. This
will attempt to download the certificate to the nanoBTS. However this process is not
guaranteed to succeed – one reason for failure would be if the Security Possible
attribute’s value wasn’t “No Certificate”, as it is only possible to download a certificate
to a nanoBTS which doesn’t already have one.
The CRL Download Status displays the results of several checks that BTS Installer
has performed on the certificate revocation list .sdp file specified on the Download tab
of the BTS Configuration dialog (or the most recent CRL found if no file name is
specified).
If the CRL file appears valid, the Download CRL button is enabled. This will attempt to
download the certificate revocation list to the nanoBTS.