Installation Instructions
Table Of Contents
- nanoBTS Installation and Test Manual
- 1 Introduction
- 2 Overview
- 3 Customer safety and regulatory information (CENG0133)
- 4 BTS Hardware Installation (CENG0210)
- 5 PSU Installation Guide (CENG0033)
- 6 BTS Installer User Guide (CENG0048)
- Introduction
- 6.2 Capabilities
- 6.3 Concepts
- 6.4 Getting Started
- 6.5 User Interface Reference
- 6.6 The DHCP Server
- 6.7 BTS Attribute Reference
- 6.7.1 The BTS Configuration Dialog box
- 6.7.2 Current Values Display
- 6.7.3 Identifying a nanoBTS
- 6.7.4 How Defaults Work
- 6.7.5 Enabling Configuration Phases
- 6.7.6 The BTS tab
- 6.7.7 The DHCP tab
- 6.7.8 The Unit ID tab
- 6.7.9 The NV Attr (1) tab
- 6.7.10 The NV Attr (2) tab
- 6.7.11 The NV Attr (3) tab
- 6.7.12 The NV Attr (4) tab
- 6.7.13 The Download tab
- 6.8 Using Network Listen
- 6.9 Using BTS Installer via a proxy
- 6.10 Connecting to a nanoBTS via SSL
- 6.11 Configuration File Reference
© ip.access Ltd
COMPANY CONFIDENTIAL CENG0336_XE_nanoBTS_Installation_and_Test_Manual.doc
- 126 -
6.10 Connecting to a nanoBTS via SSL
BTS Installer is capable, when not operating in proxy mode, of connecting to a
nanoBTS using an authenticated encrypted SSL (secure sockets layer) connection.
6.10.1 Enabling secure connections
A number of conditions must be satisfied before an SSL connection can be set up.
Firstly BTS Installer must be correctly installed:
• The user must be operating in a territory to which it is possible to export the
cryptographic technology used.
• BTS Installer must be being used in a Windows environment, using Windows
2000 SP4 or Windows XP or later.
• The Aladdin eToken run time environment must be installed.
• The eToken must be plugged into a USB port.
eToken
The first time the eToken is plugged into a USB port the new hardware wizard will
appear and also the user will be prompted to allow the system to install a number of
certificates:
• The user must permit the new hardware wizard to run normally.
• The user must permit the system to install these certificates.
When BTS Installer is started and it successfully detects the eToken it will prompt the
user for a password. The password is specific to the eToken.
• The user must enter the correct password.
If the user fails to enter the correct password then BTS Installer will continue to
operate but will only make insecure (non-SSL) connections to nanoBTSs.