Installation Instructions
Table Of Contents
- nanoBTS Installation and Test Manual
- 1 Introduction
- 2 Overview
- 3 Customer safety and regulatory information (CENG0133)
- 4 BTS Hardware Installation (CENG0210)
- 5 PSU Installation Guide (CENG0033)
- 6 BTS Installer User Guide (CENG0048)
- Introduction
- 6.2 Capabilities
- 6.3 Concepts
- 6.4 Getting Started
- 6.5 User Interface Reference
- 6.6 The DHCP Server
- 6.7 BTS Attribute Reference
- 6.7.1 The BTS Configuration Dialog box
- 6.7.2 Current Values Display
- 6.7.3 Identifying a nanoBTS
- 6.7.4 How Defaults Work
- 6.7.5 Enabling Configuration Phases
- 6.7.6 The BTS tab
- 6.7.7 The DHCP tab
- 6.7.8 The Unit ID tab
- 6.7.9 The NV Attr (1) tab
- 6.7.10 The NV Attr (2) tab
- 6.7.11 The NV Attr (3) tab
- 6.7.12 The NV Attr (4) tab
- 6.7.13 The Download tab
- 6.8 Using Network Listen
- 6.9 Using BTS Installer via a proxy
- 6.10 Connecting to a nanoBTS via SSL
- 6.11 Configuration File Reference
© ip.access Ltd
COMPANY CONFIDENTIAL CENG0336_XE_nanoBTS_Installation_and_Test_Manual.doc
- 117 -
Control Description
Apply Frequency Sync
Options
If ticked, the settings of the other controls will be used.
If not ticked, the Frequency Quality Threshold will be
set to 0, the List flag will be set to “Report a single
Frequency Error”, and the Set flag will be set to “Don’t
adjust the clock”.
Frequency Quality
Threshold
A threshold value for the measured Frequency
Quality. Channels for which the measured Frequency
Quality is below the set threshold
shall not be included in the test results. Range: 0..31.
Setting this control to 0 means that all results will be
included regardless of measured Frequency Quality.
Flags - List If set to “Report a single Frequency Error”, a single
Frequency Error value will be displayed, having been
derived by combining the errors on all the measured
channels. If set to “Report all individual Frequency
Errors”, the errors for the measured channels will be
displayed separately.
Flags - Set If set to “Don’t adjust the clock”, the measured
Frequency Errors will be displayed, but the nanoBTS’s
clock will not be adjusted. If set to “Adjust the clock to
correct the reported errors” the nanoBTS’s clock will be
adjusted as well as the error(s) being displayed.