Installation Instructions
Table Of Contents
- nanoBTS Installation and Test Manual
- 1 Introduction
- 2 Overview
- 3 Customer safety and regulatory information (CENG0133)
- 4 BTS Hardware Installation (CENG0210)
- 5 PSU Installation Guide (CENG0033)
- 6 BTS Installer User Guide (CENG0048)
- Introduction
- 6.2 Capabilities
- 6.3 Concepts
- 6.4 Getting Started
- 6.5 User Interface Reference
- 6.6 The DHCP Server
- 6.7 BTS Attribute Reference
- 6.7.1 The BTS Configuration Dialog box
- 6.7.2 Current Values Display
- 6.7.3 Identifying a nanoBTS
- 6.7.4 How Defaults Work
- 6.7.5 Enabling Configuration Phases
- 6.7.6 The BTS tab
- 6.7.7 The DHCP tab
- 6.7.8 The Unit ID tab
- 6.7.9 The NV Attr (1) tab
- 6.7.10 The NV Attr (2) tab
- 6.7.11 The NV Attr (3) tab
- 6.7.12 The NV Attr (4) tab
- 6.7.13 The Download tab
- 6.8 Using Network Listen
- 6.9 Using BTS Installer via a proxy
- 6.10 Connecting to a nanoBTS via SSL
- 6.11 Configuration File Reference
© ip.access Ltd
COMPANY CONFIDENTIAL CENG0336_XE_nanoBTS_Installation_and_Test_Manual.doc
- 105 -
6.8.3.2 ARFCN Lists
Figure 59 - ARFCN Lists
The ARFCN Lists tab allows the user to select channels to be either tested or not as
required. To define a set of channels to test, select the Apply White List check box
and then select the required ARFCNs from the list in the left hand panel. This will set
Listen to test these ARFCNs only. To select ARFCNs to be explicitly ignored, select
the Apply Black List check box and then select the required ARFCNs from the list in
the right hand panel. These ARFCNs will then not be used in the test.
If neither the Apply White List nor the Apply Black List check boxes are selected, all
RF channels in the relevant GSM band will be tested.
Note that for the BCCH Information test and the Frequency Synchronisation test, if a
BCCH Channel Usage test has been run BTS Installer automatically uses its results to
populate the ARFCN White List, but the user may override this.