Installation Instructions
Table Of Contents
- nanoBTS Installation and Test Manual
- 1 Introduction
- 2 Overview
- 3 Customer safety and regulatory information (CENG0133)
- 4 BTS Hardware Installation (CENG0210)
- 5 PSU Installation Guide (CENG0033)
- 6 BTS Installer User Guide (CENG0048)
- Introduction
- 6.2 Capabilities
- 6.3 Concepts
- 6.4 Getting Started
- 6.5 User Interface Reference
- 6.6 The DHCP Server
- 6.7 BTS Attribute Reference
- 6.7.1 The BTS Configuration Dialog box
- 6.7.2 Current Values Display
- 6.7.3 Identifying a nanoBTS
- 6.7.4 How Defaults Work
- 6.7.5 Enabling Configuration Phases
- 6.7.6 The BTS tab
- 6.7.7 The DHCP tab
- 6.7.8 The Unit ID tab
- 6.7.9 The NV Attr (1) tab
- 6.7.10 The NV Attr (2) tab
- 6.7.11 The NV Attr (3) tab
- 6.7.12 The NV Attr (4) tab
- 6.7.13 The Download tab
- 6.8 Using Network Listen
- 6.9 Using BTS Installer via a proxy
- 6.10 Connecting to a nanoBTS via SSL
- 6.11 Configuration File Reference
© ip.access Ltd
COMPANY CONFIDENTIAL CENG0336_XE_nanoBTS_Installation_and_Test_Manual.doc
- 103 -
6.8.3 Configuring a Network Listen Test
In order to configure a test, first select the required test from the tabs on the left hand
side of the Network Listen window. Then select the Configure Test button on the
toolbar:
Figure 57 - Configure Test Button
which will bring up the Configure Test dialog box for the selected test.
All Network Listen tests other than the Transmit Beacon test have the following tabs
on their Configure Test dialog boxes:
• Test Options
• ARFCN Lists
• RXLEV Threshold
All of the Network Listen tests, including the Transmit Beacon test, also have the
following tab on their Configure Test dialog boxes:
• Advanced
Some tests have additional tabs for parameters that are specific to the test in question.
These parameters are described in the same section as the test itself.
The common parameters are described in the following subsections.