Installation Manual

COMPANY CONFIDENTIAL CENG0210_XB Hardware Installation -

nanoBTS.doc

1.8 Mounting the nanoBTS

The location of each nanoBTS is shown on the installation floor plan produced at the

network planning stage. The network wiring must be complete before the nanoBTS

can be installed and commissioned. The nanoBTS should be placed on a wall at or

above head height or on a ceiling.

Remove the nanoBTS from the bracket by sliding the removal tool over the central fin

between the bracket and the body of the unit to disengage the locking spring, slide

bracket to separate it from the main body of the unit. The tool may be inserted from

the top or bottom of the nanoBTS

Figure 11 - nanoBTS Bracket Removal

Position the bracket on the wall and mark the position of the four screw holes. The top

of the bracket MUST be positioned uppermost. Ensure that the bracket is level and

sufficient clearance is maintained to allow the unit to be located on the bracket (at

least 80mm from the bracket to the top of wall and 120mm from the side of the

bracket to a side wall). See the diagram below, Figure 12 - Fixing the wall bracket.

80mm min

120mm min

Figure 12 - Fixing the wall bracket

Drill the four holes in the positions marked previously and insert wall plugs (if

required) and fix the mounting bracket securely to the wall. The bracket is designed to

allow the nanoBTS unit to be mounted with the connections at the bottom of the unit.

Slide the nanoBTS onto the bracket and ensure that the retaining spring engages into

the indent at the rear of the unit.