Installation Manual

COMPANY CONFIDENTIAL CENG0210_XB Hardware Installation -

nanoBTS.doc

1.7 Cabling the nanoBTS

Figure 8 - nanoBTS Connections

1.7.1 Ethernet

Each nanoBTS must be connected to an Ethernet switch or hub via either a 109

ip.access single power inserter or 126 ip.access Powered Ethernet Switch. Refer to

CENG0033 for details of the power supply connections.

1.7.2 Timing Interface Bus (TIB) – Multi-TRX only

The Timing Interface Bus (TIB) is used to provide clock and signaling between the

nanoBTS when operating in a Multi-TRX configuration.

The TIB OUT from the Master TRX must be connected to the TIB IN of the slave

TRX. This in turn has its TIB OUT connected to the next TRX in the chain. See

Figure 9 - TIB Connections