Installation Manual
© ip.access Ltd Page 5 of 12
COMPANY CONFIDENTIAL CENG0210_XB Hardware Installation -
nanoBTS.doc
1.6 IP Configuration
• Connect the nanoBTS up as shown in Figure 5 nanoBTS Connections and
power on the nanoBTS
Figure 5 - Local BTS Connection
• Start the BTSInstaller application
• If the IP address of you PC is not shown the IP Address window (see Figure 6)
Figure 6 - BTSInstaller Interface
• Click on the “Configure” button and select the network interface, then IP
address that is being used to connect to the nanoBTS then click on the “OK”
button.
• In the DHCP pane, click on the “Pool“ button and then the “Add” button
• Enter the IP address for the nanoBTS and click on the “OK” button.
• In the DHCP pane, click on the “Stop” and then “Start” button, to make the
DHCP server take the new IP address pool.
• Under the BTS Status pane, click on the “New” button
• From the “BTS tab”, enter the MAC address of the nanoBTS (see label on the
side of the nanoBTS
• From the “DHCP tab”, Enable the “DHCP Configuration” tick box and enter
the Subnet Mask and Router address. If no router is used leave the router
address as 0.0.0.0
• From the “Unit ID” tab, Enable the “Configure Unit ID” tick box and enter the
Site ID. If the nanoBTS is part of a multi-TRX site also enter the TRX ID.
• From the ”NV Attr (1)” tab, enable the “NV Attr Configuration” tick box and
select the “Configure Flags” tick box and set “F1”, “F2” and ”F3” to the “ON”
state.